Superstrut

Strut End Cap for A series channel. Quick installation. Adds a polished look to Racking and Trapeze systems. Prevents accumulation of dirt and Debris. Bag of 2 pieces.

Strut End Cap for B series channel. Quick installation. Adds a polished look to Racking and Trapeze systems. Prevents accumulation of dirt and Debris. Bag of 2 pieces.

1-1/8 inch Steel Snap-Guard Cushioned Clamp with SilverGalv finish.

1/2 in. Steel Pipe Strap with GoldGalv finish.

Steel Track Support with Hot-Dip Galvanized finish.

Steel End Cap with knockouts, GoldGalv finish. For use with 'A' series channel.

Channel, 14 Gauge, 1-5/8 Inch x 13/16 Inch, Length 2 Feet 4 Inches, Half Slot Pre-Galvanized Steel with 9/16 Inch x 1-1/8 Inch Slots on 2 Inch Centers

2 inch Steel Light Duty Adjustable Clevis Hanger with Black finish.

Securing Brackets. (Polycarbonate). (2) brackets secure Blox directly to roof with M-1 Adhesive. Use brackets for wind, water and snow loads. Blox not included.

Height Extension. 1.5 Inch. Fastens directly on top of Blox with # 10 screws provided or elevated with extension rods.

Channel Joiner Strap. U Shaped Fitting. 2 Hole. 3/4 Inch Diameter. 16 UNF Thread. Overall Length 4-1/2 inches. Thickness 3/32 Inch - 12 Gauge. Depth 1-11/32 Inch. Inside Width 1-3/8 Inch. SilverGalv Finish. Will not form white rust when left outdoors. Will not chip, peel or crack. Superior corrosion resistant. Ends and punched holes are protected. Clean, paintable surface. 25 Pieces.

Extension Rods. 12 Inch. (2) 1/2 Inch treaded rods, (8) nuts, (4) washers. Zinc plated.

Steel Insulation Protection Shield with GoldGalv finish.

Fitting, 90 Degree, Height 2-1/4 Inches, Base Length 3-1/2 Inches, Hole Diameter 9/16 Inches, Type 316 Stainless Steel

Bracket - Channel. Cantilever. 18 Inch Depth Halt Slot Channel X 4-5/8 Inch Plate. 2 Holes in plate. Design load 550 pounds. Zinc coating is applied by hot-dipping after fabrication. Is in conformance with ASTM A-123, Grade 65 specification standards. Minimum of 2.5 mill thickness.

Three hole Stainless Steel Z-Support. For attaching 'A' series channel.

Bolt, Hex Head Cap, Size 1/2 x 1-3/4 Inches, Electro-Galvanized Steel

Channel, Half Slot, 9/16 inch X 1-1/8 inch slots on 2 Inch centers. A Series, 12 Gauge, Depth 1-5/8 inches X Width 1-5/8 inches. 10 Foot Length. Zinc coating is applied by hot-dipping after fabrication. Is in conformance with ASTM A-123, Grade 65 specification standards. Minimum of 2.5 mill thickness.

3-1/2 inch 316 Stainless Steel Pipe Strap.

End Cap, Electro-Galvanized Steel, For use with E-1200 Series Channel