Bosch
DCNM-LSYS
System server software license
- Get up to 90 days payment terms from 500+ suppliers
- Reselling discounts up to 40%!
Send request for price
1
Payment methods:
Specifications
- Country of Origin
- Netherlands
- Gross Weight (Lbs)
- n/a
- Net Weight (Lbs)
- n/a
- Length (In)
- n/a
- Width (In)
- n/a
- Height (In)
- n/a
- Material
- F.01U.287.751
Technical Specifications
- Control
- 0 0x00 Best effort 0x00 None
- PTP follow-up, delay response, audio
- 46 0x2E EF 0xB8 High
- CPU passmark: RAM: Free disk space: Ethernet card
- >= 7000* 16 GB 50 GB 1 GB
- Gbit Ethernet
- IEEE802.3 Switch latency is maximally 10µSec with Gbit.Valid for both copper and/or fiber ports.
- Data
- DSCP dec DSCP hex DSCP Label TOS byte (hex) Switch Priority queue
- MAC table >1000
- n.a. To avoid the switch starts broadcasting unicast packets because it runs out of space.
- Up to 750 devices with identification or participant images
- Windows server 2012 R2 64 bits (including .NET Framework 3.5 feature), or: Windows server 2016 (including .NET Framework 3.5 feature).
- Up to 750 devices & without identification or participant images
- Windows server 2012 R2 64 bits (including .NET Framework 3.5 feature), or: Windows server 2016 (including .NET Framework 3.5 feature).
- Requirement
- Standard Settings
- Quality of ServiceWith strict priority
- DiffServ To make sure PTP synchronization packets and audio packets get priority over control packets.OMNEO uses QoS on IP level to avoid synchronization and audio problems on busy networks. Although the system does work without problems on relatively quiet networks (< 10% network load) it is important to configure your network switches correctly.The used QoS is Differentiated Services or DiffServ, which is part of the Type of Services field (ToS) in the IP header. For more details on DiffServ & IP header, see Wikipedia.
- (reserved)
- 8 0x08 CS1 0x20 Low
- Less than 100 devices & without identification or participant images
- Windows server 2012 R2 64 bits (including .NET Framework 3.5 feature), or: Windows server 2016 (including .NET Framework 3.5 feature).
- Packet forwarding in HW per port >1.2Mpps
- n.a. If SW is responsible for packet switching, this would result in variable latency which is unacceptable.
- Disable RSTP (when no cable loops are used)
- Rapid Spanning Tree Protocol (RSTP) is required when (cable) loops are created for redundancy. When no loops are created, RSTP needs to be disabled for opti
- CPU passmark RAM Free disk space Ethernet card
- >= 6000* 8 GB 20 GB 1 GB
- Less than 100 devices with identification or participant images
- Windows server 2012 R2 64 bits (including .NET Framework 3.5 feature), or: Windows server 2016 (including .NET Framework 3.5 feature).
- PTP sync, delay req
- 56 0x38 CS7 0xE0 Highest
- Disable EEE
- IEEE 802.3az Most implementations of EEE cause problems because of implementation flaws. A good implementation should work, but does not save energy since the PTP synchronization avoids this. Therefore, EEE must always be disabled.
Documents
Data Sheet
DownloadOther Categories
ActuatorsBlocksCables, Pipes & HosesCompressorsControlCouplings & FittingsCylinders & PistonsElectronicsFiltersHVACIndustrial PC's & HMIsLightingLinear techniqueMotorsPower SupplyPower TransmissionPumps & ValvesRenewable energyRoboticsSeals, Rings & ConnectorsSensors & Measuring DevicesTools and AccessoriesCNCOther