Fluke

FLUKE 3540 FC KIT

FLUKE 3540 FC KIT
FLUKE 3540 FC KIT
FLUKE 3540 FC KIT
  • Get up to 90 days payment terms from 500+ suppliers
  • Reselling discounts up to 40%!
Sign-Up
Send request for price
1
Payment methods:
Request a Quote and we will send you information on availability and price.

Electromagnetic compatibility (EMC)

International
IEC 61326-1: Industrial
Korea (KCC)
Class A Equipment (Industrial Broadcasting & Communication Equipment)
USA (FCC)
47 CFR 15 subpart B. This product is considered an exempt device per clause 15.103.

Calculated min/max values times

Voltage
Full cycle RMS (20 ms at 50 Hz, 16.7 ms at 60 HZ)
Current
Half cycle RMS (10 ms at 50 Hz, 8.3 ms at 60 Hz)
Power
200 ms

WiFi

Supported modes
Direct connection and connection to infrastructure
Security
WPA2-AES with pre-shared key

Single and three-phase topologies

Wiring configurations
1-Φ, 1-Φ IT, Split-phase, 3-Φ wye, 3-Φ wye IT, 3-Φ wye balanced, 3-Φ delta, 3-Φ Aron/Blondel (2-element delta), 3-Φ delta open leg, 3-Φ high leg delta, 3-Φ delta balanced. Currents only (load studies)

Current inputs

Number of inputs
3, mode selected automatically for attached sensor
Current sensor output voltage Clamp
500 mVrms / 50 mVrms; CF 2.8
Current sensor output voltage Rogowski coil
150 mVrms/15 mVrms at 50 Hz, 180 mVrms/18 mVrms at 60 Hz; CF 4; all at nominal probe range
Bandwidth (-3 dB)
42.5 Hz to 3.5 kHz
Scaling
1:1 and variable

Environmental specifications

Operating temperature
0 °C to +45 °C (+32 °F to +113 °F)
Storage temperature
<20 °C to +60 °C (-4 °C to +140 °F), with battery: -20 °C to +50 °C (-4 °F to +122 °F)
Operating humidity
<10 °C (<50 °F) non condensing || +10 °C to +30 °C (+50 °F to +86 °F) ≤95 % || +30 °C to +40 °C (+86 °F to +104 °F) ≤75 % || +40 °C to +45 °C (+104 °F to +113 °F) ≤45 %
Operating altitude
2000 m (6,500 ft) (up to 4,000 m derate to 1000 V CAT II/600 V CAT III/300 V CAT IV)
Storage altitude
12,000 m (39,000 ft)
IP Rating
IEC 60529:IP50, in connected condition with protection caps in place
Vibration
MIL-T-28800E, Type 3, Class III, Style B

Wireless radio with adapter

Frequency range
2412 MHz to 2462 MHz
Output power
<100 mW

Data acquisition

Resolution
16-bit synchronous sampling
Sampling frequency
10.24 kHz at 50/60Hz, synchronized to mains frequency
Input signal frequency
Mains 50/60 Hz (42.5 to 69 Hz)
Data storage
Internal flash memory (not user replaceable)
Memory size
Typical 1 offline logging session of 1 week with 1 second intervals. The number of possible logging sessions and logging period depends on user requirements.
Measured parameters
Voltage, current, frequency, THD V, THD A, power, power factor, fundamental power, DPF
Averaging interval
1 s
Total harmonic distortion
THD for voltage and current is calculated on 25 harmonics

Interfaces

USB-A
Firmware updates, max. supply current: 120 mA

Voltage inputs

Number of inputs
4 (3 phases and neutral)
Maximum input voltage
1000 Vrms (1700 Vpk) phase to neutral
Input impedance
10 MΩ each phase to neutral
Bandwidth
42.5 Hz to 3.5 kHz
Scaling
1:1, variable

Power supply

Voltage range
Nominal 100 V to 500 V (85 V min to 550 V max) using safety plug input
Mains power
Nominal 100 V to 240 V (85 V min to 265 V max) using IEC 60320 C7 input
Power consumption
Maximum 50 VA (max. 15 VA when powered using IEC 60320 input)
Standby power
<0.3 W only when powered using IEC 60320 input
Efficiency
≥68.2 % (in accordance with energy efficiency regulations)
Mains frequency
50/60 Hz ±15 %
Battery power
Li-ion 3.7 V, 9.25 Wh, customer-replaceable
On-battery runtime
Up to 4 hr (up to 5.5 hr in energy saving mode)
Charging time
<6 hr

Safety

IEC 61010-1
IEC mains input: Overvoltage Category II, Pollution Degree 2 || Voltage terminals: Overvoltage Category IV, Pollution Degree 2

General specifications

Color LCD display
4.3-inch active matrix color TFT, 480 pixels x 272 pixels, resistive touch panel
Warranty
3540 FC and built-in power supply: 2 years (battery not included)
Warranty Accessories
1 year
Calibration cycle
2 years
Dimensions (WxHxD 3540 FC
19.8 x 16.7 x 5.5 cm (7.8 x 6.6 x 2.2 in)
Dimensions (WxHxD Detachable power supply
13.0 x 13.0 x 4.5 cm (5.1 x 5.1 x 1.8 in)
Dimensions (WxHxD 3540 FC with power supply attached
19.8 cmx 16.7 x 9 cm (7.8 x 6.6 x 4.0 in)
Weight 3540 FC
1.1kg (2.5 lb)
Weight
1.1kg (2.5 lb): Power supply
Tamper protection
Kensington lock

Documents

Data Sheet

Download