SMART1050SLT

Overview

UPC Code

037332119902

UPS Type

Line-Interactive

Output

Output Volt Amp Capacity (VA)

1050

Output kVA Capacity (kVA)

1.05

Output Watt Capacity (Watts)

650

Nominal Voltage Details

120V default (voltage selection via back panel switches)

Frequency Compatibility

50 / 60 Hz

Frequency Compatibility Details

Automatic frequency selection

Output Voltage Regulation (Line Mode)

-13%, + 15%

Output Voltage Regulation (Battery Mode)

+/- 5%

Output AC Waveform (AC Mode)

Sine wave

Output AC Waveform (Battery Mode)

Pure Sine wave

Nominal Output Voltage(s) Supported

100V; 110V; 120V

Output Receptacles

(8) 5-15R

Individually Controllable Load Banks

No

Input

Rated input current (Maximum Load)

6.1A (120V), 6.6A (110V), 7.2A (100V)

Nominal Input Voltage(s) Supported

100V AC; 110V AC; 120V AC

UPS Input Connection Type

5-15P

UPS Input Cord Length (ft.)

6

Recommended Electrical Service

15A 120V

Input Phase

Single-Phase

Battery

Full Load Runtime (min.)

7 min. (650w)

Half Load Runtime (min.)

19 min. (325w)

DC System Voltage (VDC)

24

Battery Recharge Rate (Included Batteries)

Less than 6 hours from 10% to 90% (typical, full load discharge)

Internal UPS Replacement Battery Cartridge

RBC24-SLT

Battery Access

Battery access door

Battery Replacement Description

Hot-swappable, user replaceable batteries

Expandable Runtime

No

Voltage Regulation

Voltage Regulation Description

Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 95 to 145 (120v), 87 to 133 (110v), 83 to 121 (100v)

Overvoltage Correction

Voltage reduction of 12% applies when input is 127 to 145 (120v), 116 to 133 (110v), 111 to 121 (100v)

Undervoltage Correction

Voltage boost of 14% applies when input is 95 to 108 (120v), 87 to 99 (110v), 83 to 90 (100v)

User Interface, Alerts & Controls

Switches

2 Switches control off/on power status and alarm-cancel/self-test operation; rear panel protected switches support nominal voltage selection

Alarm Cancel Operation

Power-fail alarm can be silenced using alarm-cancel switch

Audible Alarm

Audible alarm indicates power failure and overload conditions

LED Indicators

Status LEDs indicate line power, battery power, AVR, overload and replace battery status - with a 3-LED level meter for load and battery charge level

Site Wiring Fault Indication

Rear panel site wiring fault LED

Surge / Noise Suppression

UPS AC Suppression Joule Rating

690

UPS AC Suppression Response Time

Instantaneous

UPS Dataline Suppression

1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet

EMI / RFI AC Noise Suppression

Yes

Physical

Cooling Method

Fan

Primary Form Factor

Tower

Primary UPS Depth (mm)

335

Primary UPS Height (mm)

259

Primary UPS Width (mm)

173

Shipping Dimensions (hwd / in.)

13.30 x 17.90 x 9.30

Shipping Weight (lbs.)

38.40

UPS Housing Material

Steel

UPS Power Module Dimensions (hwd, in.)

10.2 x 6.8 x 13.2

UPS Power Module Weight (kg)

16.33

UPS Power Module Weight (lbs.)

36

Environmental

Operating Temperature Range

+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius.

Storage Temperature Range

+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius.

Relative Humidity

0 to 95%, non-condensing

AC Mode BTU / Hr. (Full Load)

107

Battery Mode BTU / Hr. (Full Load)

455

AC Mode Efficiency Rating (100% Load)

95%

Audible Noise

Audible Noise < 50 dBA at Front Side 1 Meter

Communications

Network Management Cards

SNMPWEBCARD ; WEBCARDLX ; RELAYIOCARD

Network Monitoring Port Description

Supports detailed monitoring of UPS and site power conditions

PowerAlert Software

For local monitoring via the UPS’s built-in communication ports, download PowerAlert Local software at http://www.tripplite.com/poweralert

Communications Cable

USB and DB9 cabling included

WatchDog Compatibility

Supports Watchdog application, OS and hard-reboot restart options for remote applications.

Network UPS Tools Compatibility

NUT compatible. See the full list of Tripp Lite NUT compatible UPS systems at http://www.networkupstools.org/stable-hcl.html?manufacturer=Tripp Lite

Communications Interface

USB (HID enabled); DB9 Serial; Slot for SNMP/Web interface

Line / Battery Transfer

Transfer Time

4-6 milliseconds

Low Voltage Transfer to Battery Power (Setpoint)

95V (120V), 87V (110V), 83V (100V)

High Voltage Transfer to Battery Power (Setpoint)

145V (120V), 133V (110V), 121V (100V)

Special Features

Cold Start (Startup in Battery Mode During a Power Failure)

Cold-start operation supported

High Availability UPS Features

Hot swappable batteries

Certifications

UPS Certifications

Tested to UL1778 (USA); Tested to CSA (Canada); Tested to NOM (Mexico); Meets FCC Part 15 Category B (EMI)

Warranty

Product Warranty Period (Worldwide)

2-year warranty, 3 year with registration. Note: Registration is required for 3-year warranty.

Connected Equipment Insurance (U.S., Canada & Puerto Rico)

$250,000 Ultimate Lifetime Insurance

Documents