PT-RQ13K

Specifications

Brightness

10,000 lumens

Resolution

5,120 x 3,200 pixels (Quad Pixel Drive - ON)

Lamp

3-Chip DLP Laser

Power supply

AC 100-240 V, 50/60 Hz

Power consumption

1,270 W (0.3 W with STANDBY MODE set to ECO. 4 W with

DLP™ chip | Panel size

22.9 mm (0.9 inches) diagonal (16 -10 aspect ratio)

DLP™ chip | Display method

DLP™ chip x 3 (R, G, B), DLP™ projection system

DLP™ chip | Pixels

4,096,000 (2,560 x 1,600) x 3, total of 12,288,000 pixels

Refresh Rate

240 Hz

LENS

Optional powered zoom/focus lenses

Light source

Laser Diode (Laser class - Class 1)*Class 3R for North America.

Screen size

1.78-25.4 m (70-1,000 inches) (16 -10 aspect ratio)

Center-to-corner uniformity

90%

Contrast

20,000 -1 (full on/full off, in Dynamic Contrast 3 mode)

Scanning frequency | SDI

SD-SDI signal SMPTE ST 259 compliant (YCBCR 4 -2 -2 10-bit) - 480i, 576i

Keystone correction range

Vertical - ±40° (±22° with the ET-D75LE50, ±28° with the ET-D75LE6, +5° with the ET-D75LE90), horizontal - ±15° (0° with the ET-D75LE90)

Optical axis shift | Vertical

±59% (±44% with the ET-D75LE6), (+74-84% with the ET-D75LE90),

Optical axis shift | Horizontal

±29% (±19% with the ET-D75LE6), (-12-16% with the ET-D75LE90),

Installation

Ceiling/floor, front/rear

Terminals | SDI IN 1

BNC x 1,

Terminals | SDI IN 2

BNC x 1,

Terminals | SDI IN 3

BNC x 1,

Terminals | SDI IN 4

BNC x 1,

Terminals | Frame Sync IN/OUT

BNC x 1, (frame-synchronizing timing signal)

Terminals | Frame Sync OUT

BNC x 1, (frame-synchronizing timing signal)

Terminals | SERIAL IN

D-sub 9-pin (female) x 1 for external control (RS-232C compliant)

Terminals | SERIAL OUT

D-sub 9-pin (male) x 1 for link control

Terminals | Remoter 1 In/Out

M3 x 1 for link control (for wired remote control)

Terminals | REMOTE 2 IN

D-sub 9-pin (female) x 1 for external control (parallel)

Terminals | DIGITAL LINK/LAN

RJ-45 x 1 (for network, DIGITAL LINK connection (HDBaseT™ compatible),

Terminals | Expansion Slot

x 2 (SLOT 1，SLOT 2), SLOT NX (Compatible with Optional Board)

Power cord length

3.0 m (9 ft 10 in)

Cabinet materials

Molded plastic

Dimensions (W x H x D)

578 x 323.5 x 740 mm

Weight

49 kg (108.0 lbs) (without lens)

Operating noise

46 dB

Operating temperature

Ambient operating temperature - 0°C to 45°C (32 °F to 113 °F).

Applicable software

Logo Transfer Software, Multi Monitoring & Control Software,

Technology

3-chip DLP Laser

Documents